What To Do And What Not To Do During Fiber Optic Cable Installation

By Frances Richardson


In the recent past, telecommunication industry has flourished owing to introduction of fiber optic cable. Telecommunications industry greatly influences other sectors within the region. The advancement of this industry also enhanced positive influence to businesses. To ensure that this is achieved it is important to ensure that cables are properly installed. During Fiber Optic Cable Installation, instructions of manufacturer should be followed to the letter.

There are many advantages associated with this kind of technology. These cables enhance fast transmission of data. Their speed is comparable to that of light. It has been found to be only thirty one percent slower than light. Companies and homes enjoying this technology in City San Francisco Bay Area suffer from less signal losses owing to its low attenuation. This is really advantageous especially to businesses because fewer disruptions are experienced.

Users of these cables do not suffer from electromagnetic interferences. This is possible because they do not transmit electricity. This ability makes them very good and cables are able to perform their duties as required. The fact that they do not transmit electricity makes them experience less risks of catching fire. Materials that make them are also resistant to burning. They are resistant to breakages, meaning that they last for longer period of time.

To commence the process of installation it is very important to conduct survey in the area intending to install cables. Then follow the instructions of the manufacturer. This will make the process successful and convenient. When installing cables within indoors, one may either decide to place them above the ceiling for efficiency. It may also be installed within raceways. For outdoor installations, it may be buried underground or done aerially above the poles for efficiency.

Pulling of cables during installation ought to be done with care. Excessive pulling could be disastrous and dangerous. So as to comprehend what to do and what not to do, it is always important to commence by reading the manual of manufactures. It is important to pull the fiber using force that does not cause splicing of fibers. Manufactures normally recommend strength members with which each type is to be pulled with, because cables are different.

Care should also be taken when bending them. It is important to note that these cables are different, hence one should not be treated the same as the other. Different cables have different bend radius. When pulling, ensure that you do not cause twisting. This is highly discouraged owing to the fact that they are unhealthy for the cable.

It is recommended to use swivel pulling eye to enhance connection between cables and pull rope. This is important in that it prevents pulling tension, which creates twisting forces to the cable. The people performing installation are encouraged to roll it off the spool rather than turning the spool. This is intended to lower chances of twisting. When too much of it has been rolled from spool it is advisable to place it in figure eight to avoid incidences of twisting.

It is recommendable that support should be enhanced after short intervals. This will resist the cable from twisting which is not recommendable. Dropping them is better than upward pulling of cables. Dropping should be done in a vertical manner.




About the Author:



Aucun commentaire:

Enregistrer un commentaire